uClinux for H8/300H on Running H8/3068 Board

Note
Although the board currently treated here is commercial elegance, it is unknown whether it can receive except Japan.

Since there was an exactly good board of H8/3068F, uClinux was port.

This document is made to uClinux-2.0.39

Board Spec.

want you to download the following file.

Because more than one Kernel and rootdisk prepares it, I want you to download a necessary thing.

There is variously setup when I use network.

BOOTP Server
RedBoot acquires an IP address with BOOTP in starting. When BOOTP is not usable, Manual operation needs to set an IP address.
TFTP/HTTP Server
Because download size is big, the one that there was is convenient.
NFS Server
It is necessary when I use NFSRoot.

Same as attachment of Diskless Boot.

Please write in RedBoot which I downloaded at built-in Flash. It is necessary in order to activate uClinux.

Please activate serial terminal program. Communication attachment is 38400bps 8bit 1stop parity none.

Please switch on a board. A message of RedBoot should be indicated.
Please identify attachment as connection when I do not succeed.

Operation of RedBoot please watch a help.

Please load it to the following addresses.

kernel	0x400000
rootimage	0x4a0000

Rootimage is unnecessary when I use NFSRoot.

I set command line after 0x5ffe00, and please execute it from 0x400000. If RedBoot supports, it can start with "exec".

When terminal is connected to SCI1, please appoint "console=/dev/ttyS1".