PJSC（Pump Jet Solenoid Controller）はArduinoを使用したバイク用燃料噴射コントローラです。このプロジェクトは、オープンソースECUプロジェクト『Speeduino』をベースにしています。
[PJSC v1.10]2ストロークエンジンのREQ_FUEL計算式を変更
branches/PJSC_SPARK/reference/PJSC.ini (diff)| @@ -1636,7 +1636,7 @@ | ||
| 1636 | 1636 | tireCircumference = scalar, U16, 162, "mm", 1, 0, 0, 65535, 0 |
| 1637 | 1637 | |
| 1638 | 1638 | dfcoTPSdotEnabled = bits, U08, 164, [0:0], "Off", "On" |
| 1639 | - isolateNumTooth = bits, U08, 164, [1:1], "No", "Yes" | |
| 1639 | + isolateNumTooth = bits, U08, 164, [1:1], "Yes", "No" | |
| 1640 | 1640 | unused15_164 = bits, U08, 164, [2:7] |
| 1641 | 1641 | dfcoTPSdotThresh = scalar, S16, 165, "%/s", 1.0, 0.0, -2000, 0, 0 |
| 1642 | 1642 | dfcoTPSdotMulti = scalar, U08, 167, "%", 1.0, 0.0, 0.0, 100.0, 0 |
| @@ -3529,7 +3529,7 @@ | ||
| 3529 | 3529 | field = "VR1 Internal pullup", pullupTrigger ;[PJSC v1.10] |
| 3530 | 3530 | field = "VR2 Internal pullup", pullupTrigger2 ;[PJSC v1.10] |
| 3531 | 3531 | ;[PJSC v1.10] field = "Primary base teeth", numTeeth, { TrigPattern == 0 || TrigPattern == 2 || TrigPattern == 11 || TrigPattern == 18 || TrigPattern == 19 || TrigPattern == 21 } |
| 3532 | - field = "Primary base teeth", numTeeth, { TrigPattern == 0 || TrigPattern == 1 || TrigPattern == 2 || TrigPattern == 11 || TrigPattern == 18 || TrigPattern == 19 || TrigPattern == 21 } ;[PJSC v1.10] | |
| 3532 | + field = "Primary base teeth", numTeeth, { TrigPattern == 0 || (TrigPattern == 1 && isolateNumTooth == 1) || TrigPattern == 2 || TrigPattern == 11 || TrigPattern == 18 || TrigPattern == 19 || TrigPattern == 21 } ;[PJSC v1.10] | |
| 3533 | 3533 | field = "Primary trigger speed", TrigSpeed, { TrigPattern == 0 || TrigPattern == 2 } |
| 3534 | 3534 | field = "Missing teeth", missingTeeth, { TrigPattern == 0 } |
| 3535 | 3535 | field = "Trigger angle multiplier", TrigAngMul, { TrigPattern == 11 } |
